Making use of Waterproof LED Strip Lights

Whenever exploring the lighting options available for you in a home or business, you are occasionally restricted by certain factors. An example is safety.

Using lights in potentially wet conditions is generally considered a bad thing. After all, electricity and water do not mix. However , you can find lighting options available to help you overcome this particular.

LED Strips are available with, or without, a protective waterproof covering. A waterproof coating is usually essential when installing strip lights inside your kitchen, bathroom, close to windows or outside, where there is a high opportunity they will come into contact with moisture around shoes and faucets, or condensation resulting from food preparation and your morning shower program.

The level of protection offered by waterproof films varies and can be usually based on their IP rating. The standard regarding waterproofing LED Strip is an IP65 covering, which is suitable for most interior programs. A clear silicone gel is applied to the upper side of the strip light and offers protection against splashes, condensation and water droplets. This type of strip is not suitable for use outside or even complete immersion.

One of the chief benefits of using IP65 is that the strip could be cut without compromising protection.

When utilizing LED Strips in harsher circumstances, you will need a greater degree of protection. A good IP67 coating will enable you to occurs strip lights outside, but you may need an IP68 (hermetically sealed) enclosure to completely submerge them. Most IP67 strips use a hollow plastic sleave, which, when cut, instantly leads to the strip to become exposed. In this case a special capping process is needed to reseal the strip and it is best to have your retailer perform the necessary work.

Remember, it is always better to be secure than sorry. Overproofing your remove lights is not a terrible thing and will usually only cost you an extra handful of quid. Definitely worth it considering even a small amount of water can short circuit the particular strip lights.

Don’t forget about your peripheral units either. All LED strip lights require a driver and in the case of RGB Strips, controllers plus amplifiers. IP rated versions of such units can be purchased, but it is always recommended to keep them clear of wet situations if possible. If you are cutting and soldering your own strip light, also ensure that any connections you make are usually sealed and proofed against dampness.

Leave a Reply

Your email address will not be published. Required fields are marked *